Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

li_ battery _1d_for_thermal_model

Please login with a confirmed email address before reporting spam

Dear sir or madan,
I got a question when modeling a layer-structured liion battery consited of 2 cells connected in parallel.
is the "li_ battery _1d_for_thermal_model" only designed for the cylindrical battery?
or is it a generic model for all the liion batteries?
cause when I simulate the temperatrue distribution,
I need the heat source generated by the 1d battery model, right?
how can i get the heat source ?
just use the "li_ battery _1d_for_thermal_model",
only change the geometry parameters and definations, keep the other equations the same?
Thanks a lot!
Best regards!
GU ZEZHI


1 Reply Last Post 17 dic 2013, 22:03 GMT-5

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 17 dic 2013, 22:03 GMT-5
Please, no body can answer me?
Thanks a lot for your attention!
Please, no body can answer me? Thanks a lot for your attention!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.