Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

PLASMA SIMULATION ERROR

Posted 13 gen 2014, 07:32 GMT-5 0 Replies

Ali Sferi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,
I'm trying to replace only Ar-type plasma with He-type in one of the demo models (using cross section files), but the error occurs during execution process as described below:
"not convergence at time step" ... or "not consistency found in initial values".
please guide me about the error occurred.(comsol 4.3b)
regards
0 Replies Last Post 13 gen 2014, 07:32 GMT-5
COMSOL Moderator

Hello Ali Sferi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content