Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How do I clear a default value

Posted 2 feb 2014, 09:39 GMT-5 Low-Frequency Electromagnetics Version 4.4 0 Replies

David Segal
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

I am trying to work through the Comsol 3D inductor model step by step but am stuck. It downloads with the setup for the frquency domain study. and I can't run the stationary study. I need to define a boundary feed but that boundary is defined as Magnetic Insulation I and is non-applicable for anything else. I can define a Magnetic Insulation II that overrides Magnetic Insulation I but am still stuck with that darn non-applicable boundary 58. It is impossible to delete anyrhing from that initial Magnetic Insulation boundary list.
Thanks for Advice
David
0 Replies Last Post 2 feb 2014, 09:39 GMT-5
COMSOL Moderator

Hello David Segal

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content