Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Bending curvature of beam

Please login with a confirmed email address before reporting spam

Hello, I have a problem when doing a simulation with a beam bending.

I want to apply the specific radius of curvature to beam.

How to solve the problem by using the boundary condition?



1 Reply Last Post 10 mar 2014, 05:16 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 10 mar 2014, 05:16 GMT-4
Hi

if you have a regular beam, a moment load will give you a radius of curvature type shape.
Then you can use the new 4.4 "curv" variables, see the help "Geometric Variables and Mesh Variables" to measure the average curvature and drive the moment load until you get the desired value

--
Good luck
Ivar
Hi if you have a regular beam, a moment load will give you a radius of curvature type shape. Then you can use the new 4.4 "curv" variables, see the help "Geometric Variables and Mesh Variables" to measure the average curvature and drive the moment load until you get the desired value -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.