Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
full model of a coil spring?
Posted 18 mar 2014, 14:35 GMT-4 3 Replies
Please login with a confirmed email address before reporting spam
Hello,
I'd like to model a coil spring, to include changes in diameter due to compression, and longitudinal and torsional modes. Is this a reasonable task for Comsol, or would it be prohibitively complex?
Perhaps it's already been done and there are sample models?
Thanks!
-Andy
I'd like to model a coil spring, to include changes in diameter due to compression, and longitudinal and torsional modes. Is this a reasonable task for Comsol, or would it be prohibitively complex?
Perhaps it's already been done and there are sample models?
Thanks!
-Andy
3 Replies Last Post 18 mar 2014, 22:31 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi Andrew,
It’s a reasonable task in my opinion. Select physically accurate boundary conditions depending on whether the ends of the coil are allowed to rotate or twist. Also if you compress the spring enough then account for contact.
Nagi Elabbasi
Veryst Engineering
It’s a reasonable task in my opinion. Select physically accurate boundary conditions depending on whether the ends of the coil are allowed to rotate or twist. Also if you compress the spring enough then account for contact.
Nagi Elabbasi
Veryst Engineering
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Thanks Nagi.
I presume I would need a moving mesh, since the displacement is greater than the width of one of the helicies?
My force input is from a speaker coil attached to one end of the spring, which would exert force only in the axial direction.
Thanks again,
Andy
I presume I would need a moving mesh, since the displacement is greater than the width of one of the helicies?
My force input is from a speaker coil attached to one end of the spring, which would exert force only in the axial direction.
Thanks again,
Andy
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi Andy,
No need for a moving mesh. COMSOL uses a Lagrangian framework for structural problems so if the deformations are large the mesh will move “automatically”.
Nagi Elabbasi
Veryst Engineering
No need for a moving mesh. COMSOL uses a Lagrangian framework for structural problems so if the deformations are large the mesh will move “automatically”.
Nagi Elabbasi
Veryst Engineering