Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

holes creating in membrane

Posted 7 mag 2014, 05:23 GMT-4 MEMS & Nanotechnology, MEMS & Piezoelectric Devices Version 4.3b 4 Replies

adsadasd adadad
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

i am making a cantilever mems .I have create a membrane but i have some problems that how can a i create muti hole and slots in the plate .
4 Replies Last Post 5 ago 2015, 07:17 GMT-4
Marwan Nafea
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 7 mag 2014, 12:20 GMT-4
Did you build your model directly in 3D, or 2D then 3D?
Did you build your model directly in 3D, or 2D then 3D?
adsadasd adadad
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 10 mag 2014, 00:00 GMT-4
I am making 3D model using block height 250 um , width 80um ,and depth 1 um. I want to create a multi hole in this block . I am making membrane of MEMS switch .
I am making 3D model using block height 250 um , width 80um ,and depth 1 um. I want to create a multi hole in this block . I am making membrane of MEMS switch .
Marwan Nafea
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 10 mag 2014, 11:00 GMT-4
From my opinion, I think it is better if you draw your structure in 2D, then you export your geometry to a file. Use that file later in a 3D model and extrude it by 1 um.
From my opinion, I think it is better if you draw your structure in 2D, then you export your geometry to a file. Use that file later in a 3D model and extrude it by 1 um.
Subhabrata Nath
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 5 ago 2015, 07:17 GMT-4
Hi I am working in a similar project!Can u plz rply as I have some doubt regarding it?
Hi I am working in a similar project!Can u plz rply as I have some doubt regarding it?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content