Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to make COMSOL re-check Paramters and Variables ?
Posted 5 giu 2014, 07:28 GMT-4 Version 4.4 2 Replies
Please login with a confirmed email address before reporting spam
How can I make COMSOL recheck a variable defined in Global Definitions?
I mis-typed an entry in the variables in the global definitions. I used this variable name to define a boundary temperature. COMSOL complained correctly that the unit was wrong.
I corrected the entry in the global variable definition, but the error message in the Heat Transfer module, where I use this variable is completely unaffected from any change i make there and states all the same for this variable name.
How can I make COMSOL re-check the contents of the variable in the module?
I mis-typed an entry in the variables in the global definitions. I used this variable name to define a boundary temperature. COMSOL complained correctly that the unit was wrong.
I corrected the entry in the global variable definition, but the error message in the Heat Transfer module, where I use this variable is completely unaffected from any change i make there and states all the same for this variable name.
How can I make COMSOL re-check the contents of the variable in the module?
2 Replies Last Post 6 giu 2014, 09:38 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
What error do you get in the heat transfer module?
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
It claims the units were wrong.
That was the case in my first definition, but was corrected later.
I could even change the unit in the variable from [s] to [km] and the message was still [1/s] was the wrong unit.
I could avoid the message easily by renaming the variable. So I suppose the old contents of the variable was not updated.
That was the case in my first definition, but was corrected later.
I could even change the unit in the variable from [s] to [km] and the message was still [1/s] was the wrong unit.
I could avoid the message easily by renaming the variable. So I suppose the old contents of the variable was not updated.