Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Modeling tension and compression in curved blob
Posted 29 giu 2014, 10:10 GMT-4 1 Reply
Please login with a confirmed email address before reporting spam
I have a model of a blob (ellipsoid) that is displaced into a bowl-shape (prescribed displacement driven by a gaussian equation in the z direction). There is no movement in the x or y directions. I would expect to see tension on the convex surface as it is displaced outward, and compression on the concave surface as it is displaced inward, but instead we see only vertical stresses acting throughout the cross-section in the XZ or YZ planes (model attached). I've tried changing the type of stress from von mises to pretty much every other option (including strain, etc.) and can't seem to get anything that looks remotely like tension/compression (horizontal lines in the cross section rather than vertical). Any suggestions?
Thanks!
Attachments:
Hello ronit
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I have exactly the same issue, do you have any solutions to this problem?
Antoine