Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Contact Modeling in Stationary a Study

Posted 30 lug 2014, 16:25 GMT-4 Mesh, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers, Structural Mechanics Version 4.4 3 Replies

Rachel Foreman
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to create a simulation of two layers of hyperelastic material (a dense polymer and a foam layer) under compression. The layers are not bonded together, but they are in contact. Both materials are represented by Ogden hyperelastic constitutive model. The displacement discretization is set to 'quadratic'. I am not getting convergence when I am using contact (it works without the contact). Any advice (maybe regarding solver or component/physics settings to tinker with?) is greatly appreciated.
3 Replies Last Post 31 lug 2014, 17:46 GMT-4
Josh Thomas Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 30 lug 2014, 16:34 GMT-4
Rachel-

Without looking at your mph file, but just considering the text of your post here are a couple things:

1) Instead of solving for the full load/displacement in one shot, use a parametric approach that incrementally ramps up the loading/displacement. This helps a lot with convergence and gives physical intermediate results up to the point of convergence failure.

2) Use linear element discretization for better contact convergence.

--
Best regards,
Josh Thomas
AltaSim Technologies
Rachel- Without looking at your mph file, but just considering the text of your post here are a couple things: 1) Instead of solving for the full load/displacement in one shot, use a parametric approach that incrementally ramps up the loading/displacement. This helps a lot with convergence and gives physical intermediate results up to the point of convergence failure. 2) Use linear element discretization for better contact convergence. -- Best regards, Josh Thomas AltaSim Technologies
Rachel Foreman
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 31 lug 2014, 17:28 GMT-4
Thanks for your input, Josh. I tried your suggestions, but still no convergence. Any other ideas?
Thanks for your input, Josh. I tried your suggestions, but still no convergence. Any other ideas?
Josh Thomas Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 31 lug 2014, 17:46 GMT-4
I would try doing a displacement controlled rather than a load controlled problem. I don't believe all of your rigid body modes for the separate bodies are being restrained properly. Also, I would recommend solving using a linear elastic material model for both parts and troubleshooting the contact problem. Then, add in the non-linear material model.

Adding one non-linearity at a time is good practice!

--
Best regards,
Josh Thomas
AltaSim Technologies
I would try doing a displacement controlled rather than a load controlled problem. I don't believe all of your rigid body modes for the separate bodies are being restrained properly. Also, I would recommend solving using a linear elastic material model for both parts and troubleshooting the contact problem. Then, add in the non-linear material model. Adding one non-linearity at a time is good practice! -- Best regards, Josh Thomas AltaSim Technologies

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content