Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Re-using physics interface as a study step
Posted 3 ago 2014, 08:37 GMT-4 RF & Microwave Engineering, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers Version 4.4 0 Replies
Please login with a confirmed email address before reporting spam
In my study I use EMW interface to calculate a set of parameters (let's say, polarization-'p')
and then implement these results in the next step, which uses a different EMW interface.
Schematically:
Step 1(EMW1)--> Step 2 (EMW2(EMW1.p))
Now I'm trying something a bit more complicated, but can't find an elegant way to do so-
I want to calculate the first step twice, each time with one parameter changed (let's call it 'd'), and then implement both results in the same advanced step.
again, schematically:
Step 1(EMW1(d=1)), Step 1(again) (EMW1(d=2)) -->Step 2 (EMW2(EMW1(d=1).p,EMW1(d=2).p))
How can I do that without duplicating the first EMW inteface? (which is done manually, can't find a way to duplicate it automatically)
Can I use Parametric sweep just for one step, and then implement it in the next one? If so, how can I refer to the results in the previous step, and choose which of the results sets to use?
Thanks,
Shay
Hello Shay Keren-Zur
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.