Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
deformed geometry for Electromagnets
Posted 6 set 2014, 19:52 GMT-4 Low-Frequency Electromagnetics, Geometry, Mesh, Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization, Studies & Solvers Version 4.3, Version 4.3a, Version 4.3b, Version 4.4 0 Replies
Please login with a confirmed email address before reporting spam
i defined a moving armature by using deformed geometry in AD\DC module .also auto Remeshing defined .when the distortion exceed from 1 ,comsol remesh geometry again .
but after three remeshing ,comsol give an error(A problem occurred when building mesh feature 'Reference 1')also inverted mesh element can be seen .
does any one know how can i solve this problem ?
thanks with regards
Hello Mamad Moka
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.