Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Simulate elastic substrate

Posted 7 nov 2014, 13:57 GMT-5 Materials, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers, Structural Mechanics 0 Replies

Harshad Gupta
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am very new to Comsol and trying to simulated a elastomeric substrate with nanoparticle filled in it. I have following problems
I simulated only a rectangular film made of elastomer. I applied load at one end and opposite was fixed. But I could not achieve the behaviour as normally seen. Also the strain produced is very less and same in case of all the loads. Please suggest proper model I should use to obtain proper behaviour of the elastomeric film.

Do I have to consider the bulk modulus and shear modulus as well. As of now I am only including Young's Modulus, Poission's ratio, and density.
0 Replies Last Post 7 nov 2014, 13:57 GMT-5
COMSOL Moderator

Hello Harshad Gupta

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content