Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Edge/surface parameters s s1 s2

Ronald Terrazas Mallea

Please login with a confirmed email address before reporting spam

Hi,

I am trying to implement the mode of a solid particle "pushed" by Thermocapillary convection on water. Now I am trying to test the effect of the curvature around the particle in the velocity field and in the particle velocity.

The problem is that my Heat source term (a*b*c.... * (Height_liquid_layer - y) ), depends on the height of the liquid layer that is not constant anymore when I have the deformed surface. Furthermore as I am using a moving mesh, I think it would be pretty messy to use one kind of interpolation function. So I was wondering if its possible to obtain the surface coordinates somehow (in my case the Y surface coordinate).

Reading the tutorials I found that I could the "Edge/surface parameters s s1 s2" but I do not understand how to use them to retrieve the X or Y value of the surface. I have been looking in the forums without success.

Kind regards,
Ronald Terrazas Mallea

0 Replies Last Post 12 nov 2014, 11:22 GMT-5
COMSOL Moderator

Hello Ronald Terrazas Mallea

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.