Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to specify initial values for incident waves at boundaries of domain?

Posted 10 mag 2010, 10:38 GMT-4 0 Replies

Peter Rakich
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi All,

I am using the RF module to model wave propagation with the 2D "In plane hybrid mode wave" solver. I'm scripting various simulations in matlab, and I'd like to figure out a way to specify the E and H fields at the boundaries of the system so that I can launch arbitrary waves into the simulation.

I haven't found a way to do this.

Any help is appreciated.

Thanks!

-p
0 Replies Last Post 10 mag 2010, 10:38 GMT-4
COMSOL Moderator

Hello Peter Rakich

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content