Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

problems with non-isothermal three phase flow in the porous media

Posted 27 mar 2015, 09:32 GMT-4 Fluid & Heat, Heat Transfer & Phase Change, Porous Media Flow Version 4.4 0 Replies

Shirley Long
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have built a non-isothermal three phase flow in the formation: low temperature CO2 injection into the formation to displace oil. Set the phase saturation, pressure and temperature as the primary variable.

I have encountered this problem with my model: everything is ok, but the pressure drop sharply after short time of flooding.
The saturation model and pressure model I use are from the paper NIU BEN wrote Coupling Miscible Flow and Geochemistry for Carbon Dioxide Flooding into North Sea Chalk Reservoir and add a energy model.

Now I have built 2D and 3D models.

Can anybody give me some instructions???
Tks

0 Replies Last Post 27 mar 2015, 09:32 GMT-4
COMSOL Moderator

Hello Shirley Long

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content