Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

parametric sweep and post processing => data set => cut line

Please login with a confirmed email address before reporting spam

for a cylinder with PARAMETRIC SWEEP over length of it, i have defined a CUT LINE across circular surfaces of the cylinder by giving parameter values in LINE DATA. Problem is that it is taking parameter value which is given at GLOBAL=>DEFINITION=>PARAMETERS, and not the values given in STUDY=> PARAMETRIC SWEEP=> STUDY SETTING, due to this i am not getting results in post processing.

2 Replies Last Post 15 ago 2015, 10:07 GMT-4

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 31 lug 2015, 02:13 GMT-4
model file attach with this post

--
KSM
model file attach with this post -- KSM

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 15 ago 2015, 10:07 GMT-4
I am facing the same problem. Have you found a solution?
I am facing the same problem. Have you found a solution?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.