Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
modelling of membrane deformation and microvalves
Posted 22 lug 2015, 08:15 GMT-4 Microfluidics, Structural Mechanics Version 4.3 2 Replies
Please login with a confirmed email address before reporting spam
I recently built a PDMS microvalves, which is constituted by a thin membrane layer on top and a thick semicircular microwell at the bottom. I want simulate the deformation of membrane under different pressure, and study when and under how much pressure will the membrane fully deformed and cause fully closure of the microwell.
There are two problems i have encountered. the first is about the visualization of the results. COMSOL always display the exaggerated deformation rather than the actual deformation calculated under different pressure, which won't allow me a straight display of the deformation level, and closure of microwell. the second is that when the membrane deforms, it is not taking the distance between the membrane and microwell as the maximum deform distance. even after I set the microwell surface as fix constraint, the deform results still shows the membrane deformed through the well bottom. Isn't this wired?
Did any of you work with anything similar? how did you cope with this problem?
Hello Jane Li
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I'm working on a similar simulation right now and keep getting error from COMSOL. Which version were you using? Did you do 2D or 3D? Did you combine the solid mechanic module with other modules? I'm simulating the PDMS channel deformation under different pressure. Appreciate your help
Please login with a confirmed email address before reporting spam
I'm also trying to simulate a similar scenario can you please guide me what modules did you guys use with solid mechanics i tried couple of them and used multi physics module to couple them but keep getting an error plus i'm using a 2d geometry.
Regards
Adil