Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How a boundary condition of a port in Loudspeaker enclosure should be applied ??

Please login with a confirmed email address before reporting spam

Hi, I'm researching on the control of loudspeaker.

In my current stage, I should design a port of the loudspeaker enclosure.

That is, I should design the port that is normally located in the enclosure box as a square hole.

Until now, I've put the boundary condition on the outermost acoustic surface of port as a radiation boundary condition (in Acoustic domain).

Unfortunately, the expected results of pressure response according to the variation of port design are not obtained.

The boundary condition I gave is not appropriate??
Or should I give a more detail boundary condition on it??

Is there anyone has a similar experience to my case??

Sincerely yours,




0 Replies Last Post 12 ago 2015, 04:26 GMT-4
COMSOL Moderator

Hello Youngeun Cho

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.