Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
give a thickness to a geometry
Posted 25 ago 2010, 07:44 GMT-4 2 Replies
Please login with a confirmed email address before reporting spam
hi everybody
I made the geometry in CATIA and then imported it to comsol.I want to know if there is a way Ito give a thickness to the geometry(that is 3D,curved tube like)..
any help?
thanx
maral
I made the geometry in CATIA and then imported it to comsol.I want to know if there is a way Ito give a thickness to the geometry(that is 3D,curved tube like)..
any help?
thanx
maral
2 Replies Last Post 28 feb 2017, 16:21 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
If you have imported a 2D geometry into COMSOL, you can embed, extrude, or revolve it into 3D
this is still slightly version dependent in V4, probably fully impelemneted again in next version (hope so ;)
--
Good luck
Ivar
If you have imported a 2D geometry into COMSOL, you can embed, extrude, or revolve it into 3D
this is still slightly version dependent in V4, probably fully impelemneted again in next version (hope so ;)
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
7 years ago
Hello Maral,
The Design Module includes the "Thicken" functionality that turns a surface into a solid object by giving the surface a thickness: see www.comsol.com/design-module for some screenshots.
This functionality is much more general than an extrusion, which only operates on planar surfaces.
Best regards,
Jeff
The Design Module includes the "Thicken" functionality that turns a surface into a solid object by giving the surface a thickness: see www.comsol.com/design-module for some screenshots.
This functionality is much more general than an extrusion, which only operates on planar surfaces.
Best regards,
Jeff