Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
3D fluid flow in an L-shaped pipe
Posted 2 set 2010, 16:40 GMT-4 Fluid & Heat 0 Replies
Please login with a confirmed email address before reporting spam
I really appreciate any help. I am trying to model a 3D fluid flow model. This is an L-shaped pipe with a curved corner. I am doing a stationary model. I'm using version 4.0.
Inlet: laminar inlet, 0.05 m/s
Outlet: laminar outlet, 0 pressure
rho: 1000 kg/m^3
eta: 0.001 Pa*s
I am new with Comsol. There is a message saying there's a problem in Stationary1. I see this as a simple geometry, and it's just in preparation for more complex geometries that I'll need to model later on! Any ideas?
Thank you so much
Sylvana
Hello Sylvana Garcia
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.