Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Joule Heating of a Copper Coils
Posted 23 set 2015, 18:00 GMT-4 Electromagnetic Heating, Low-Frequency Electromagnetics, Heat Transfer & Phase Change, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 5.1 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
I am trying to see the heating of a coil of copper wire if a current of 1.2 [A] is put through it. I feel like this should be easily possible with COMSOL.
I am using the Joule Heating module and have defined a current density in (what I am simulating right now) a tube of copper, but I am not getting nonsensical results.
Any help or advice would be greatly appreciated and I have attached the file.
Very Respectfully,
Will
I am trying to see the heating of a coil of copper wire if a current of 1.2 [A] is put through it. I feel like this should be easily possible with COMSOL.
I am using the Joule Heating module and have defined a current density in (what I am simulating right now) a tube of copper, but I am not getting nonsensical results.
Any help or advice would be greatly appreciated and I have attached the file.
Very Respectfully,
Will
Attachments:
1 Reply Last Post 25 set 2015, 09:10 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
9 years ago
Dear William,
please take a look at the model "inductive heating":
www.comsol.com/model/inductive-heating-of-copper-cylinder-148
This shows how to work with a model like this.
Best regards,
Frank
please take a look at the model "inductive heating":
www.comsol.com/model/inductive-heating-of-copper-cylinder-148
This shows how to work with a model like this.
Best regards,
Frank