Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
To find stress constants on Photonic crystal fiber structure?
Posted 23 nov 2015, 07:50 GMT-5 Geometry Version 4.3 1 Reply
Please login with a confirmed email address before reporting spam
I am trying to find out the stress constants on a 2D Hi-Bi PCF structure, which can be used to find out the birefringence pressure sensitivity. I tried with the structural mechanics module, where the 2D structure was designed and boundary load was applied on the surface.
Once I am simulating it I am getting an error stating
Failed to find a solution, relative error is more than relative tolerance?
Is there any solution for that?
Once I am simulating it I am getting an error stating
Failed to find a solution, relative error is more than relative tolerance?
Is there any solution for that?
1 Reply Last Post 23 nov 2015, 08:28 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
9 years ago
Hello Siraj,
Hard to say for sure without seeing your mph file, but my guess would be that you may not have imposed sufficient boundary conditions to eliminate all rigid body motions (see www.comsol.com/community/forums/general/thread/95201/ ).
Best,
Jeff
Hard to say for sure without seeing your mph file, but my guess would be that you may not have imposed sufficient boundary conditions to eliminate all rigid body motions (see www.comsol.com/community/forums/general/thread/95201/ ).
Best,
Jeff