Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.
Visualizza gli articoli presentati alla COMSOL Conference 2020
The present work aims to describe the behavior of the interface using the method of load transfer between fiber and matrix in a composite material. Our contribution was first to simulate the mechanical behavior of a composite, for a given radius of the fiber was able to automate the ... Per saperne di più
The fabrication of piezo aluminium composite modules for sensor and actor applications with mass production technologies is in the scope of the SFB/Transregio 39 PT-PIESA project funded by the (German Research Foundation). After forming of cavities with a width of 0.3 mm into aluminium ... Per saperne di più
For preservation of artefacts in a museum the indoor climate is often restricted to a very narrow interval for temperature, but most of all for relative humidity. In old buildings the museum conditions of artefacts, e.g. near cold walls, mostly are not in line with museum recommendations ... Per saperne di più
A compacted bentonite clay buffer is planned to be used as a part of the engineered barrier system in the KBS-3 concept for the disposal of spent nuclear fuel. Simulations together with experimental studies are needed to ensure that bentonite fulfills its safety functions in the concept. ... Per saperne di più
Objective of this paper is the development and implementation of a finite element model, in a COMSOL Multiphysics context, for the prediction of the aeroelastic behavior of rotor blades. In particular, the attention is focused on new generation blades characterized by curved elastic ... Per saperne di più
This paper will give a short overview of use of COMSOL Multiphysics for analyzing ancient Greek and Roman catapults with the main focus on the energy storing torsion springs. Catapults have been known and used in the Greek and Roman world from around 399 BC and a fully standardized ... Per saperne di più
This paper proposes the design of a 3-Degree of Freedom(DoF) motor based on surface acoustic waves in elastic solids. The rotor is propelled by wave fields, for linear and rotational motion respectively, in the stator, that can be steered by the driving signal of the piezoelectric ... Per saperne di più
The present study focuses on the design and analysis of a single-engine, propeller-driven general aviation airplane. Initial weight estimation based on the initial sketch and the design mission profile is conducted. The estimated weight and other design parameters are used to define the ... Per saperne di più
The main objective of the present work is to perform stress analysis on composite laminates under unaxial/biaxial loading to serve as a preliminary data for test verification. A detailed calculation based on the Classical Lamination Theory was performed for a laminate. The material used ... Per saperne di più
In this paper we compare the results from a bending cantilever beam experiment with the theoretical values and COMSOL finite element simulation results. In the experiment a simple cantilever beam with a hole is loaded at the end. Measurements are recorded by four strain gauges mounted on ... Per saperne di più