Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Moving interface
Posted 28 ott 2010, 16:57 GMT-4 1 Reply
Please login with a confirmed email address before reporting spam
Hi
I move an interface and get e new domain, but I can not generate a new mesh from a deformed mesh.
How can I generate a new mesh?
Best
I move an interface and get e new domain, but I can not generate a new mesh from a deformed mesh.
How can I generate a new mesh?
Best
1 Reply Last Post 29 ott 2010, 01:25 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
there are a few limits within ALE, you are not allowed to change the topology (create any new boundaries or domains, because then you need to "redefine" the model from scratch and COMSOl cannot always decide alone what to do/apply onto the new domains. And you need a new remeshing.
This can only be approached in aparametric loop (V4) with a gemetrical change and remeshing, provided COMSOL know how to apply new BC's on the new boundaries
--
Good luck
Ivar
there are a few limits within ALE, you are not allowed to change the topology (create any new boundaries or domains, because then you need to "redefine" the model from scratch and COMSOl cannot always decide alone what to do/apply onto the new domains. And you need a new remeshing.
This can only be approached in aparametric loop (V4) with a gemetrical change and remeshing, provided COMSOL know how to apply new BC's on the new boundaries
--
Good luck
Ivar