Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
convection between fluid and bed
Posted 6 dic 2010, 07:12 GMT-5 1 Reply
Please login with a confirmed email address before reporting spam
If a hot fluid passes through a pipe and rejects heat to an adsorbent bed at the outside, do I have to add fluid mode to solve imcomp. navier stokes eqn.s if the vel. is const. I see that I can add convection in general heat tran. mode and I do not know that it can make the same thing as fluid mode (by entering the same vel.). Also I wonder about how can I set the convective wall condition at the contact. Comsol asks external temp (Tinf) while I should enter the temp diff. between fluid and bed. How can I enter a different temperature when I try to solve single temp. profile ?
Thanks...
Thanks...
1 Reply Last Post 6 dic 2010, 15:58 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
It was looked at 46 times , but nobody writes any thing, I can not understand. Did I asked a difficult question, or a too simple question, or a silly question that does not deserve the answer. I experienced a lot of examples, but I am living some porblems in entering the boundary settings, I thing.