Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Reusing a deformed geometry for a new study

Posted 8 mag 2017, 17:50 GMT-4 Structural Mechanics Version 5.2 0 Replies

Joseph Favata
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

My goal is to model a loading on a wire that has some slack. So, ideally, the wire should deform under some predefined displacement initial condition and then be subjected to a load.

I am trying to reuse the geometry from the initial displacement step so that the stresses associated with this displacement (which are not strictly correct because the original model did not account for slack) are not accounted for during the loading. I followed basic workflows from other forum posts, to export and import the first step's mesh, but it only yields the undeformed mesh.

Please advise.
0 Replies Last Post 8 mag 2017, 17:50 GMT-4
COMSOL Moderator

Hello Joseph Favata

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content