Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

splitting of geometry

Posted 4 ago 2011, 05:55 GMT-4 Version 3.5a 0 Replies

Muhammad Ahmad
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everyone

I have 4 outlets and 1 wall part in my geometry. The outlets are prepared with straight plan-cuts.
The largest one is the inlet condition, the other three should outlet condition. Could I separate the one inlet plane and the 3 outlet planes, using some grid separation technique or some other technique in comsol 3.5a

0 Replies Last Post 4 ago 2011, 05:55 GMT-4
COMSOL Moderator

Hello Muhammad Ahmad

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content