Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
FSI: Moving mesh (ale) vs Moving mesh
Posted 5 mag 2021, 16:45 GMT-4 Fluid & Heat, Computational Fluid Dynamics (CFD), Structural Mechanics Version 5.4 0 Replies
Please login with a confirmed email address before reporting spam
Hello,
I have the doubt of which of these two options select for my FSI simulation:
-The moving mesh in: Components-Definitions-Moving mesh-Deforming Domain
-The moving mesh (ale) in: Components-Moving mesh
If I use moving mesh (ale) in the results I can only see the deformation of the boundary separating the fluid from the solid, while if I use moving mesh I can see the meshes deforming properly not only in the boundary. Is there any difference between the two? Does it impact only to the visualization?
Thank you
Hello James Hernández
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.