Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.
Visualizza gli articoli presentati alla COMSOL Conference 2020
As a sustainable urban transport system, the tricycle might represent an adaptive mobility vehicle used to transport people and bulk load. This transport system must warranty the security of its end users, then experimental and modeling works are very useful tools in order to evaluate ... Per saperne di più
In this study, based on a bank protection structure engineering at Yangtze River, a 2D water-soil coupling model is established, in which the influence of water level fluctuation on groundwater seepage and soil shear strength is considered. According to the water level measured data of ... Per saperne di più
A wind tunnel experiment was modelled using COMSOL Multiphysics® CFD software. A k-ω coupled turbulence model was considered including the Brinkman equation for stationary air flow through a porous vegetation section. Per saperne di più
Based on the heat transfer and seepage theory in porous media, a 2D cross section of a horizontal AGF project is selected and a numerical model is set up, which is based on full coupling of temperature and flow fields by combining physical interfaces of Darcy's Law and Heat Transfer in ... Per saperne di più
Aqueous polymers used for enhanced oil recovery (EOR) application is considered a complex fluid. It can exhibit Newtonian and Non-Newtonian behavior depending on the velocity or the stresses that it is submitted during the flooding process. Therefore, the polymer flooding project ... Per saperne di più
This paper presents a multiphysics model to the convective, conductive and radiative heat transfer for the thermoelectric modules (TEMs), which are used to convert heat flux into electrical current. The model basically consists of heat transfer in solids, heat transfer in thin shells, ... Per saperne di più
In a first approach towards application of the magnetic frequency mixing technique to microfluidic structures, microplanar coils have to be designed along with sample reservoir. For this, a COMSOL Multiphysics® electrical model along with an analytical calculation is used in order to ... Per saperne di più
The successful implementation of a high-efficient latent heat storage system necessitates an appropriate experimental approach to investigate and quantify the variations of the Phase Change Material (PCM) thermal properties caused by its aging, as well as its potential demixing induced ... Per saperne di più
The recent years have witnessed a growing interest in the possibility of enhancing the information transfer per unit bandwidth by exploiting the Orbital Angular Momentum (OAM) of light in both free-space and guided scenarios. In the proposed paper, the propagation of suitable OAM ... Per saperne di più
The transducer's construction used for current measurement in medium voltage power lines for current values kA is shown. The transducer involves magnetic circuit with a gap in which a MEMS structure with a movable cantilever is placed. The beam is made of silicon with a NiFe layer. The ... Per saperne di più