Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.
Visualizza gli articoli presentati alla COMSOL Conference 2020
A device for monitoring the oxygen consumption of cells has been developed, which consists of two parts; a cell culturing platform (CCP) and an oxygen sensing chip. The CCP possesses inlet and outlet pipes to direct the fluid under the test to the cell culturing chamber through the inlet ... Per saperne di più
Multiphase flow in a microreactor was studied numerically for two immiscible liquids. Validation of the model was sought by simulating the flow behavior and mass transfer characteristics of a neutralization reaction described in the literature. Contact angles, interfacial tension and the ... Per saperne di più
This paper presents the results of modeling of a microreactor with three inputs geometry (or crow's-feet), in relation to distributions of velocities and concentrations. The objective of this work is the study of this kind of geometry with relation to fluid dynamics behavior, improving ... Per saperne di più
In this numerical study, surface acoustic waves (SAWs) are evaluated as a potential disruptive flow technology for enhancing heat transfer in microchannels. Using COMSOL Multiphysics® software, the physics governing acoustics, single-phase-fluid flow and heat transfer are coupled. The ... Per saperne di più
This paper presents the 3D model of pressure distribution in the process of magneto-rheological flow finishing. The effect of working gap on pressure distribution is studied using COMSOL Multiphysics® software. Also, the effect of different viscosity of fluids on development of pressure ... Per saperne di più
Flexography is a roll-based mass printing process used in manufacture of printed products such as sensors, self-cleaning surfaces, and flexible electronics. Flexography involves inking of a stamp wrapped around a roller, and the transfer of ink on the stamp surface to a printing ... Per saperne di più
Microcontact printing is a method for depositing patterns of thin films or molecular monolayers on surfaces using a polydimethylsiloxane (PDMS) stamp for selective mechanical contact (Figure 1). Undesired deformation of the stamp features during printing affects printed pattern quality. ... Per saperne di più
In our study of chaotic mixing, 3D velocity measurements (u,v,w) are required for evaluation of a micro mixer using a mix-prediction algorithm. The hybrid approach presented here combines 2D measurements, an imperfect numerical model, and appropriate fitting parameters. Because our ... Per saperne di più
AC electrothermal (ACET) micropumps are based on the temperature gradient caused by Joule heating or an external heat source in the bulk of an electrolyte. In this paper, a 2D simulation was performed to study the effect of substrate thickness and material (glass and silicon) for an ACET ... Per saperne di più
Flow focusing microchannels are widely used in droplet generation mechanisms. In this paper, the effect of linear vibration on the flow pattern in a flow focusing structure and the corresponding formed droplets were numerically investigated using COMSOL Multiphysics® software. The ... Per saperne di più